Topcon X35 - Xtend

X35 Monitor System Settings
4.8
7. Norac Boom Height Control - this is an
option for sprayer implements for auto boom
height control.
8. M2M (I2I) Coverage Sharing - this feature
allows coverage sharing between multiple
units when operating in the same field if this
package is purchased and configured.
9. Lock
Setup Menu When Master Switch On
- set to enabled to prevent operator from going
into settings page while unit is operating with
the master switch on.
10. Hypr
o Prostop-E - this is a locked feature for
sprayer implements for individual CAN nozzle
control.
11. Weigh Scales - this feature is enabled when
the optional Digi-Star scale link option is
installed for integrating the weigh system into
the console. Refer to Section 13.5 - Weigh
System for setup of this feature.
12. LH5000
Rate Sensor - this is a locked feature
that allows a third party device to provide rate
input to the console.
4.2.5 Xtend
This page shows the devices that have been
connected to console through the Xtend feature.
Refer to Section 13.6 - Extend Feature for
operation of this feature.
1. Maximum
Paired Devices - this is defaulted
to 2 devices allowing the user to connect more
than one device without forgetting the other
one.
2. Action - press forget to remove a device from
the
list if you don’t want it to automatically
connect to the console when in range.
Figure 4.7 - Xtend Settings