Topcon X35 - Page 67

X35 Monitor System Settings
4.7
2. Variable Rate Control - enables or disables
the use of the VRC feature in conjunction
with seed rate control of the X35 console.
If enabled this feature will allow the use of
prescription maps to vary application rates over
the mapped areas.
3. T
ask Data - allows import/export and use of
ISOBUS task data XML files.
a. The Task Data mode can only be used
with ISOBUS ECUs.
i. Enabling this feature will disable
many job menu items during
operations, because the ISOXML
task data file will contain all the
job control information and interact
directly with the ECU.
b. Look for the Task Data icon on the Job
Menu on the operation screens. If it is not
showing, then Task Data is not enabled.
Task Data must be enabled each time the
feature is used.
4. Ar
ea Counters - this will enable or disable
the area counting panel in the seeder controller
window. There are 2 options for resetting the
area counter.
a. Disabled - no area counter panel.
b.
Enabled (Stored per Job) - job area
counter
panel enabled. Area counting will
accumulate per job and will always be
reset when a new job is created or it can
be reset manually.
c. Enabled (Stored per Implement) -
implement area counter panel enabled.
Area counting will accumulate until the
implement is changed or it can be reset
manually.
d. Enabled (Stored per Job and Implement)
-
job area counter panel and implement
area counter panel enabled. There will be
two area counter panels available to record
area per job as well as keep a running
count through multiple jobs.
Figure 4.6 - Reset Area Counter Setting
5. Reset Job Area Counters - this setting
appears when the area counter is set to be
stored per job. The area counter will always
reset when the job is changed but this setting
only affects how it resets when a job is cleared
(coverage erased).
a. Never - area counter will not reset when
the
job is cleared.
b. Pr
ompt - area counter will ask if you want
to reset when the job is cleared.
c. Auto - area counter will automatically
reset
when the job is cleared.
6. W
ater Conservation - this is a locked feature
available for land leveling/drainage.