X35 ConsoleProduct Setup
7.10
7.4 Product Density
You can either measure product density, or refer to
the product density chart in Appendix C of your air
seeder tank operator's manual.
To determine the density of the applied product fill
the calibration pail full, level, and weigh (make
sure to subtract pail weight or tare scale before
weighing).
Use
following formula to get actual product
density:
Where Calibration Pail/Box Volume:
1. 7000/8000/9000
Series = 1.04 ft3 (0.029 m3)
2. 6000
Series = 1.00 ft3 (0.028 m3)
Calibration Pail/
Box volume (ft
3
)
Product Weight(lb)
Product Density (lb/ft3) =
To Next Page
Loading...
