What causes intermittent sensor readings on Topcon X35?
If you're experiencing intermittent sensor readings on your Topcon Music Mixer, check harness connections for dirt and/or corrosion and clean as required. Also, ensure proper alignment and gap. Ensure that the speed sensor to target gap is 1/32”-1/8” (1mm- 3mm).
Why is the cabin or on-frame keypad flashing on my Topcon X35 Music Mixer?
If the Topcon Music Mixer cabin or on-frame keypad is flashing, assign keypads. In setup screen go to Implement/Operator Inputs. If the issue persists, unplug the keypad and reconnect it.
How do I fix Topcon X35 cabin switchbox controls that aren't working?
If the Topcon Music Mixer cabin switchbox controls will not work, go to the Setup screen, then Implement/Operator Inputs and check if keypad switches are enabled.
Why am I not receiving a GPS signal on my Topcon X35 Music Mixer?
If you are not receiving a GPS signal on your Topcon Music Mixer, enable GGA, VTG & ZDA strings. If the signal subscription expired, contact signal supplier to re-subscribe. Check that selected COM port matches actual port that cable from receiver is plugged into. If the issue persists, contact Bourgault dealer or supplier of receiver, or connect receiver and ensure it is turned on. Use null modem adapter (switches the input/ output pin between different systems).
How to resolve fluctuating meter RPM on Topcon Music Mixer?
If you are experiencing fluctuating meter RPM on your Topcon Music Mixer, ensure a consistent ground speed. Realign the speed sensor or tighten set screws on the sprocket. If you are using 7000 A/S, replace proportional valve (usually if a problem on just one meter), compensator cartridge (could show up on any of the meters), or metering circuit priority valve (could show up on any of the meters and also in the fan speed). For 6000 A/S: Replace actuator.
Why won't the meters start on my Topcon Music Mixer?
If the meters on your Topcon Music Mixer will not start, engage the fans and ensure proper speed is set. Make sure speed is being picked up, and enter a requested rate. Check calibration factors under manual entry and enter missing calibration factor or calibrate. If ASC is on, override ASC or move to area to be seeded.
What to do if there is no ECU communication on Topcon Music Mixer?
If there is no ECU communication on your Topcon Music Mixer, verify that the profile is set up correctly. Also, check all harness connections from ECU on air seeder to monitor. Ensure harnesses are connected properly. Check battery voltage, fuse holder connections and look for damaged wiring. If the issue persists, the ECU may be faulty/damaged. In that case, contact Bourgault dealer. Also, ensure that monitor and ECU software versions are compatible.
How to fix Topcon Music Mixer monitor that will not power up?
If the Topcon Music Mixer monitor will not power up, start the vehicle and check the battery voltage. Also, check for damaged wiring or blown fuse. If the issue persists, there might be a damaged unit and it is advisable to contact Bourgault dealer for repair or replacement.
Why does my Topcon X35 monitor automatically turn off?
If the Topcon Music Mixer monitor automatically turns off, check the battery voltage, alternator output, and power cable wiring. Also, verify the fuses and check for any damaged wiring.
Why is weight not displaying on remote of my Topcon X35?
If the weight is not displaying on the remote of your Topcon Music Mixer, check the “SCOREM” number and correct if required.
General| Brand | Topcon |
|---|---|
| Model | X35 |
| Category | Music Mixer |
| Language | English |
To Next Page
