X35 Monitor Air Seeder Setup
6.54
6.6.4 Pumps Settings
These settings appear only if configured with NH3/
Liquid. You can configure settings related to the
liquid/NH3 system pumps.
Systems can have up to 4 pumps. There is a tab
for each pump.
1. Pump speed - default set to disabled (not
supported through Bourgault harnessing)
a. Enable if you wish to monitor the speed of
the liquid/NH3 system pump. (Liquid/NH3
system must be equipped with a pump
speed sensor).
2. Pulses per revolution - set this to the number
of targets/resolution that are used by the pump
speed sensor.
Figure 6.73 - Pump Settings
To Next Page
Loading...
