X35 Monitor System Settings
4.7
6. Water Conservation - this is a locked feature
available for land leveling/drainage.
7. Norac Boom Height Control - this is an
option for sprayer implements for auto boom
height control.
8. Lock Setup Menu When Master Switch On
- set to enabled to prevent operator from going
into settings page while unit is operating with
the master switch on.
9. Hypro Prostop-E - this is a locked feature for
sprayer implements for individual CAN nozzle
control.
10. Weigh Scales - this feature is enabled when
the optional Digi-Star scale link option is
installed for integrating the weigh system into
the console. Refer to Section 13.4 - Weigh
System for setup of this feature.
11. LH5000 Rate Sensor - this is a locked feature
that allows a third party device to provide rate
input to the console.
To Next Page
