Test Functions
Issue 5 - 04/01 5-3
To display the BERT results, choose BERT.
To display the service test results, choose SERVICE.
Checking the Line Configuration
+
The Configuration Check determines:
• the protocol that can be used on the line
• the layer 2 configuration in use (i.e. Point-to-Point or
Point-to-Multipoint)
When the test ends,
AuroraPlus displays the protocol and layer
2 configuration found on the line and gives you the option to
automatically re-configure
AuroraPlus for this line.
Notes
• Although the Configuration Check can distinguish
between the ETSI and 1TR6 protocols, it cannot
distinguish between ETSI, TPH and VN.
• Some ETSI networks show both Point-to-Point and
Point-to-Multipoint configurations for Basic Rate
interface: either can be used.
• A U interface may take several minutes to activate,
when you check the line configuration this may lead to
false readings.
From the Main Menu choose
TESTS.
Chap05.P65 01/05/01, 09:113
To Next Page
Loading...