Call Establishment
Issue 5 - 04/01 4-7
Press ENTER to automatically redial this number. If you do
not want to redial this number, enter a different number; the
last number dialled is overwritten.
To add digits to the end of the last number dialled, press the
CLEAR key once and enter the new digits.
To erase the last number dialled, digit by digit, repeatedly
press the CLEAR key.
Note
If you alter the service or channel settings, the last number
dialled is automatically cleared and Call Redial is not
available.
Answering Incoming Calls
How an incoming call is answered depends on the Loop
settings. If the Loop option is set to
AUTO, AuroraPlus
automatically answers incoming calls. If it is set to OFF or
MANUAL, you have to answer the call manually. Please refer to
Setting up a Loop in Chapter 3 for further information.
An incoming call is indicated by the ringer sounding. If it is
the only active call it is displayed on the screen immediately.
+ If there are other active calls press SHIFT + 4 (B Channel
selection). A screen similar to the following is displayed:
B1 CALL
SPEECH
L1 L2 L3
Accepting the call
Press the ENTER ( ) key to answer the incoming call.
Chap04s1.P65 30/04/01, 16:337
To Next Page
Loading...