Setting up your AuroraPlus
Issue 5 - 04/01 3-3
Tip
You can check AuroraPlus's current protocol and bus
configuration by performing a Status Check - please refer to
Checking AuroraPlus's Status in Chapter 5 for details.
Setting up a Loop
You can set up AuroraPlus to provide a loop on incoming calls
so that it can be used with another device for BER Testing.
If you make a self-call, AuroraPlus automatically loops the call
back on the other B-Channel.
The Loop options are as follows:
•
AUTO: Call Screening is operational, irrespective of the
service type. Please refer to Call Screening in this
chapter for further details. Successfully screened
incoming calls are answered automatically and a loop
connected. Use this setting for voice or data calls when
you wish to perform a looped-back BER Test with a
remote device. Note that the unit may be left
unattended in this mode. Connect the charger unless
AuroraPlus is line powered.
• MANUAL: Incoming calls are answered manually and
then a loop is connected. Use this setting for voice or
data calls when you wish to perform a looped-back
BER Test with a remote device. Service Checking for
outgoing calls operates normally. Call Screening can
only be used with voice (i.e. speech or 3k1). Screening
only operates if you selected
TELCHK from the CALLS
menu.
Chap03.P65 30/04/01, 16:313
To Next Page
Loading...