TrendCommunications AuroraPlus - Setting the High Layer Capability; Setting the Bearer Service

Call Establishment
Issue 5 - 04/01 4-17
Setting the High Layer Capability
Choose HLC to display the following screen.
HLC
1A2C62
Enter the setting as described in Entering Hexadecimal
Numbers.
You can enter up to 3 bytes (6 characters).
You must enter an even number of characters.
Press ENTER ( ) to confirm your choice.
Setting the Bearer Service
On the User Defined Bearer Capability screen, enter the
setting as described in Entering Hexadecimal Numbers.
You can enter up to 2 bytes (4 characters).
You must enter an even number of characters.
From the SRV screen choose USER to display the following
screen.
SIC:
1042
Press ENTER ( ) to confirm your choice.
Chap04s1.P65 30/04/01, 16:3417