EasyManua.ls Logo

Trimble GCS900 - Page 157

Default Icon
188 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Troubleshooting in theField 7
UTS tracking status Meaning
UTS battery is low The UTS instrument battery is too low to operate reliably.
UTS configuration
failed
UTS instrument configuration failed.
UTS does not support
Active Target ID
<num>
The UTS instrument does not support the MT900 target ID specified.
UTS not level The tilt compensator on the UTS instrument is out of range.
UTS not benched The UTS elevation was not set at the instrument, so the target must be
benched before use.
UTS not supported The firmware in the UTS instrument is not interoperable with the system.
UTS not supported:
Cannot determine
firmware version
The firmware in the UTS instrument is not interoperable with the system.
UTS not supported: No
Positioning support
The firmware in the UTS instrument is not interoperable with the system.
UTS not supported: No
Tracker support
The firmware in the UTS instrument is not interoperable with the system.
UTS not supported: Not
a construction UTS
The firmware in the UTS instrument is not interoperable with the system.
Auto Searching ... The UTS instrument is searching for the machine target. Only occurs if
you have selected auto search.
Check machine radio The system cannot communicate with the machine radio.
Check machine target The system cannot communicate with the machine target.
Check radio channel The radio network ID/channel number combination set up for your system
is also being used by another machine within radio range.
Comms timed out The delay in the response from the UTS instrument was greater than the
maximum allowed.
Configuring UTS The UTS instrument is being configured.
Connecting UTS The system is establishing a radio link with the UTS instrument.
Disconnecting UTS The system is dropping the radio link to the UTS instrument.
Full Searching for
Target ...
The UTS instrument is carrying out a full search for the machine target.
Machine target search
failure
System error.
Measuring Error System error.
Table 7.1 Values of the Status and UTS status field for UTS systems
GCS900 Grade Control System for Excavators Operator's Manual 157

Table of Contents

Other manuals for Trimble GCS900