EasyManua.ls Logo

Tripp Lite B092-016 - Always-On Dial-Out; Dial-Out Failover

Tripp Lite B092-016
257 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
74
• SpecifytheProbe Addresses oftwosites(thePrimary and Secondary)thattheB096-048/016istoping to determine
ifNetwork(eth0)isstilloperational
• ThencongureManagement LAN Interface (eth1) with the same IP setting that you used for the main Network
Interface (eth0) to ensure transparent redundancy
Inthismode,Network2(eth1)isavailableasthetransparentback-upporttoNetwork1(eth0)foraccessingthe
managementnetwork.Network2willautomaticallyandtransparentlytakeovertheworkofNetwork1,intheeventNetwork1
becomes unavailable for any reason.
Bydefault,theConsoleServersupportsautomaticfailure-recoverybacktotheoriginalstatepriortofailover.TheConsole
Server continually pings probe addresses whilst in original and failover states. The original state will automatically be set as
apriorityandre-establishedfollowingthreesuccessfulpingsoftheprobeaddressesduringfailover.Thefailoverstatewillbe
removedoncetheoriginalstatehasbeenre-established.
Chapter 5: Firewall, Failover and Out-of-Band
5.4 Dial-Out Access
The internal or externally attached modem on the Console Servers can be set up either
o in Failover mode,whereadial-outconnectionisonlyestablishedineventofapingfailure,or
o withthedial-outconnectionalwayson
Inbothoftheabovecases,intheeventofadisruptioninthedial-outconnection,theConsoleServerwillendeavortore-
establish the connection.
5.4.1 Always-on dial-out
TheConsoleServermodemcanbeconguredforout-dialtobealwayson,withapermanentexternaldial-uppppconnection.
• Selectthe System: Dial menu option and check Enable Dial-Out to allow outgoing modem communications
• SelecttheBaud Rate and Flow Control that will communicate with the modem
• IntheDial-Out Settings - Always On Out-of-Band field enter the access details for the remote PPP server to be called
Override DNS isavailableforPPPDevicessuchasmodems.OverrideDNSallowstheuseofalternateDNSserversfrom
thoseprovidedbyyourISP.Forexample,analternativeDNSmayberequiredforOpenDNSusedforcontentltering.
• ToenableOverride DNS,checktheOverridereturnedDNSServersbox.EntertheIPoftheDNSserversintothespaces
provided.

Table of Contents

Other manuals for Tripp Lite B092-016

Related product manuals