Unipulse F701-C - Page 8

CONTENTS
VII
6-4．Final / Set Point 2 / Set Point 1 / Compensation / Over / Under ............. 86
6-5．Negative Compensation ............................................................................ 89
6-6．Near Zero / Upper Limit / Lower Limit ...................................................... 90
6-7．Upper/Lower Limit Comparison /
Upper/Lower Limit Comparison Mode /
Near Zero Comparison / Final and Comparison /
Over/Under Comparison Mode ................................................................. 91
6-8．Complete Signal Output Mode / Complete Output Time /
Judging Time / Comparison Inhibit Time / Output Selection 2 .............. 93
6-9．Judging Times / AZ Times / At Start Near Zero Confirmation /
At Start Weight Value Confirmation / Adjust Feeding /
Adjust Feeding Time .................................................................................. 96
6-10．Net Over / Gross Over ............................................................................ 100
6-11．Weight Error / Sequence Error .............................................................. 101
7．STATISTICAL AND ACCUMULATION FUNCTION SETTING AND
OPERATION ...........................................................................102
7-1．Data Display .............................................................................................. 103
7-2．Accumulation Command ......................................................................... 103
7-3．Accumulation Clear .................................................................................. 105
7-4．Auto Accumulation Command ................................................................ 107
8．SYSTEM MODE .....................................................................109
8-1．LOCK (soft) ............................................................................................... 109
8-2．Password .................................................................................................. 109
8-3．Self-Check and Memory Clear ................................................................. 110
9．EXTERNAL INPUT/OUTPUT SIGNALS
(CONTROL CONNECTOR) ....................................................111
9-1．Control Connector-Pin Assignment ....................................................... 111
9-2．Equivalent Circuit (Input) ......................................................................... 112
9-3．Equivalent Circuit (Output) ...................................................................... 112
9-4．External Input Signal ................................................................................ 113
9-4-1．Gross/Net Switching (G/N) <Edge Input> <Level Input> ......................... 113
9-4-2．Digital Zero (D/Z ON) <Edge Input> .......................................................... 113
9-4-3．Tare Subtraction (TARE ON) <Edge Input> .............................................. 114
9-4-4．Tare Subtraction Reset (TARE OFF) <Edge Input> ................................. 114
9-4-5．Hold (HOLD) <Level Input> ........................................................................ 114
9-4-6．Judge <Level Input> ................................................................................... 115
9-4-7．Feed / Discharge <Level Input> ................................................................. 115
9-4-8．Input Signals Used in Sequence Mode ..................................................... 115