9 PARAMETER DESCRIPTIONS
In this chapter, you can find data on the most special parameters of the application. For most
parameters of the Vacon 100 application, a basic description is sufficient. You can find these
basic descriptions in the parameter tables of Chapter 5 Parameters menu. If other data is
necessary, your distributor will help you.
P1.2 APPLICATION (ID212)
In P1.2 you can make a selection of an application that is best for your process. The
applications include preset application configurations, that is, sets of predefined parameters.
The selection of the application makes the commissioning of the drive easy and reduces the
manual work with the parameters.
These configurations are loaded to the drive when the value of parameter P1.2 Application
changes. You can change the value of this parameter when you make the start up or the
commissioning of the drive.
If you use the control panel to change this parameter, an application wizard starts and helps
you to set the basic parameters related to the application. The wizard does not start, if you
use the PC tool to change this parameter. You can find data about the application wizards in
Chapter 2 Wizards.
These applications are available:
0 = Standard
1 = Local/Remote
2 = Multi-step speed
3 = PID control
4 = Multi-purpose
5 = Motor potentiometer
NOTE!
When you change the application, the contents of the Quick Setup menu change.
9.1 MOTOR SETTINGS
P3.1.1.2 MOTOR NOMINAL FREQUENCY (ID 111)
When this parameter changes, parameters P3.1.4.2 Field Weakening Point Frequency and
P3.1.4.3 Voltage at Field Weakening Point start automatically. The 2 parameters have
different values for each motor type. See the tables in P3.1.2.2 Motor Type (ID 650).
VACON · 224 PARAMETER DESCRIPTIONS
9
TEL. +358 (0)201 2121 · FAX +358 (0)201 212 205
To Next Page
Loading...
