Vacon 100 - Multi-Step Speed Application

Table 6: M1 Quick Setup
Index Parameter Min Max Unit Default ID Description
1.28 RO2 Function 0 51 3 1104 See P3.5.3.2.1
1.29 RO3 Function 0 51 1 1107 See P3.5.3.2.1
1.30 AO1 Function 0 31 2 10050 See P3.5.4.1.1
Table 7: M1.32 Local/Remote
Index Parameter Min Max Unit Default ID Description
1.32.1
I/O Control
Reference B
Selection
1 20 4 131
See P1.22
1.32.2 I/O B Control Force
DigIN
SlotA.6
425
TRUE = Force control
place to I/O B
1.32.3
I/O B Reference
Force
DigIN
SlotA.6
343
TRUE = Used frequency
reference is specified
by I/O Reference B
parameter (P1.32.1)
1.32.4 Control Signal 1 B
DigIN
SlotA.4
423
Start signal 1 when
control place is I/O B
1.32.5 Control Signal 2 B
DigIN
SlotA.5
424
Start signal 1 when
control place is I/O B
1.32.6
Keypad Control
Force
DigIN
SlotA.1
410
Force Control to
Keypad
1.32.7
Fieldbus Control
Force
DigIN
Slot0.1
411
Force Control to
Fieldbus
1.32.8
External Fault
(Close)
DigIN
SlotA.3
405
FALSE = OK
TRUE = External fault
1.32.9 Fault Reset (Close)
DigIN
Slot0.1
414
Resets all active faults
when TRUE
1.4.3 MULTI-STEP SPEED APPLICATION
You can use the Multi-step speed application with processes where more than 1 fixed
frequency reference is necessary (for example test benches).
It is possible to use 1 + 7 frequency references: 1 basic reference (AI1 or AI2) and 7 preset
references.
Make a selection of the preset frequency references with digital signals DI4, DI5 and DI6. If
none of these inputs are active, the frequency reference is removed from the analogue input
(AI1 or AI2). Give the start/stop commands from the I/O terminal (DI1 and DI2).
VACON · 28 QUICK STARTUP GUIDE
1
TEL. +358 (0)201 2121 · FAX +358 (0)201 212 205