Vacon 100 - Multi-Purpose Application Wizard

20
Set the signal range of the analogue input
0 = 0…10V / 0…20mA
1 = 2…10V / 4…20mA
21
Set a value for P3.13.2.1 (Keypad Setpoint 1) and
P3.13.2.2 (Keypad Setpoint 2)
Depends on the range set in the question 20.
22
Using the sleep function
0 = No
1 = Yes
If you give the value Yes for the question 22, you see the next 3 questions. If you give the value
No, the wizard is completed.
23
Set a value for P3.34.7 Sleep Frequency Limit Range: 0.00…320.00 Hz
24 Set a value for P3.34.8 Sleep Delay 1 Range: 0…3000 s
25 Set a value for P3.34.9 Wake-up Level The range depends on the set process unit
The PID Control application wizard is completed.
2.5 MULTI-PURPOSE APPLICATION WIZARD
The application wizard helps you to set the basic parameters that are related to the
application.
To start the Multi-purpose application wizard, set the value Multi-purpose to parameter P1.2
Application (ID 212) in the keypad.
NOTE!
If you start the application wizard from the Start-up wizard, the wizard goes directly
to question 11.
1
Set a value for P3.1.2.2 Motor Type (so that it agrees
with the nameplate of the motor)
PM motor
Induction motor
2
Set a value for P3.1.1.1 Motor Nominal Voltage (so
that it agrees with the nameplate of the motor)
Range: Varies
3
Set a value for P3.1.1.2 Motor Nominal Frequency
(so that it agrees with the nameplate of the motor)
Range: 8.00…320.00 Hz
4
Set a value for P3.1.1.3 Motor Nominal Speed (so
that it agrees with the nameplate of the motor)
Range: 24…19200 rpm
5
Set a value for P3.1.1.4 Motor Nominal Current (so
that it agrees with the nameplate of the motor)
Range: Varies
VACON · 68 WIZARDS
2
TEL. +358 (0)201 2121 · FAX +358 (0)201 212 205