Vacon 100 - Multipump Wizard

If you set Motor Type to Induction Motor, you see the next question. If your selection is PM
Motor, the value of parameter P3.1.1.5 Motor Cos Phi is set to 1.00, and the wizard goes
directly to question 7.
6
Set a value for P3.1.1.5 Motor Cos Phi (so that it
agrees with the nameplate of the motor)
Range: 0.30…1.00
7
Set a value for P3.3.1.1 Minimum Frequency
Reference
Range: 0.00…P3.3.1.2 Hz
8
Set a value for P3.3.1.2 Maximum Frequency
Reference
Range: P3.3.1.1…320.00 Hz
9 Set a value for P3.4.1.2 Acceleration Time 1 Range: 0.1…300.0 s
10 Set a value for P3.4.1.3 Deceleration Time 1 Range: 0.1…300.0 s
11
Set a value for P1.36.1 Motor Potentiometer Ramp
Time
Range: 0.1…500.0 Hz/s
12
Set a value for P1.36.2 Motor Potentiometer Reset
0 = No Reset
1 = Stop State
2 = Power Down
The Motor Potentiometer application wizard is completed.
2.7 MULTIPUMP WIZARD
To start the Multipump wizard, make the selection Activate for parameter B1.1.3 in the Quick
setup menu. The default settings tell you to use the PID controller in the one feedback / one
setpoint mode. The default control place is I/O A, and the default process unit is %.
1
Set a value for P3.13.1.4 Process Unit Selection More than 1 selection.
If your selection is other than %, you see the next questions. If your selection is %, the wizard
goes directly to question 5.
2
Set a value for P3.13.1.5 Process Unit Min Varies
3 Set a value for P3.13.1.6 Process Unit Max Varies
4 Set a value for P3.13.1.7 Process Unit Decimals 0...4
5
Set a value for P3.13.3.3 Feedback 1 Source
Selection
See the table Feedback settings in Chapter
5.13 Group 3.13: PID controller.
If you make a selection of an analogue input signal, you see the question 6. With other
selections, the wizard goes to question 7.
VACON · 70 WIZARDS
2
TEL. +358 (0)201 2121 · FAX +358 (0)201 212 205