Vacon 100 - Motor Potentiometer Parameters

Table 118: The selection of preset frequencies when P3.3.3.1 = Number of inputs
Activated digital input signal Activated frequency
reference
Preset Freq Sel2
(P3.3.3.12)
Preset Freq Sel1
(P3.3.3.11)
Preset Freq Sel0
(P3.3.3.10)
Preset frequency 0 Only if
Preset Freq 0 is set as
frequency reference
source with P3.3.3.1.5,
P3.3.1.6, P3.3.1.7 or
P3.3.1.10.
* Preset frequency 1
* Preset frequency 1
* Preset frequency 1
* * Preset frequency 2
* * Preset frequency 2
* * Preset frequency 2
* * * Preset frequency 3
* = the input is activated.
P3.3.3.10 PRESET FREQUENCY SELECTION 0 (ID 419)
P3.3.3.11 PRESET FREQUENCY SELECTION 1 (ID 420)
P3.3.3.12 PRESET FREQUENCY SELECTION 2 (ID 421)
To apply Preset frequencies 1 to 7, connect a digital input to these functions with the
instructions in Chapter 9.7.1 Programming of digital and analogue inputs. See more data in
Table 117 The selection of preset frequencies when P3.3.3.1 = Binary coded and also in Tables
Table 41 Preset frequency parameters and Table 50 Digital input settings.
9.3.4 MOTOR POTENTIOMETER PARAMETERS
The frequency reference of the Motor Potentiometer is available in all the control places. You
can change the motor potentiometer reference only when the drive is in the run state.
NOTE!
If you set the output frequency slower than the Motor Potentiometer Ramp Time,
the normal acceleration and deceleration times give limits to it.
VACON · 246 PARAMETER DESCRIPTIONS
9
TEL. +358 (0)201 2121 · FAX +358 (0)201 212 205