-10%
+10%
-10 V
-100%
+10 V
+100%
MaxFreq
Reference
AI joystick
dead zone = 10%
Analogue input
-MaxFreq
Fig. 38: The Joystick function
P3.3.5.3 JOYSTICK SLEEP ZONE (ID 385)
P3.3.5.3 JOYSTICK SLEEP DELAY (ID 386)
If the joystick reference stays in the set sleep zone for longer than the sleep delay, the drive
stops and the sleep mode activates.
The value 0 of the parameter tells that the sleep delay is not used.
NOTE!
The Joystick sleep function is available only when you use a joystick to control the
frequency reference.
9.5 JOGGING PARAMETERS
Use the Jogging function to override the normal control momentarily. You can use this
function, for example, to control the process slowly to a special status or position during
maintenance. You do not have to change the control place or other parameters.
Only when the drive is in stop state, it is possible to activate the Jogging function. You can
use 2 bi-directional frequency references. You can activate the Jogging function from the
PARAMETER DESCRIPTIONS VACON · 249
24-HOUR SUPPORT +358 (0)201 212 575 · EMAIL: VACON@VACON.COM
9
To Next Page
Loading...
Need help?
General
