Chapter 8 System Options Alpha Compact 32708612
Version: 14.12.2012 page 101 of 135
016 EXTENSION DELAY
This parameter enables the programming of a delay between trigger signal and actual
tamp movement. The delay starts with triggering (external or autom.). The EXTENS: DE-
LAY will be ignored, if the parameter APPLICATOR TRIGGER has the value “000” (cp.
page 91.)
Push [Enter] to edit the configuration parameter (in case of password query see
page 91).
Push the *buttons [] or [] to increase or reduce the parameter value.
(unit = value x 10ms, value "000" = no delay).
Push [Enter] to save the value.
Push the buttons [] or [] to get to the next configuration parameter.
Push [Start] or [Stop] to leave the parameter setting.
017 EXTENSION TIME
The „EXTENSION TIME“ defines the time that passes from the beginning of the stroke
movement until the beginning of blow-action. You set the labeler in Blow-On mode via the
value “000”. The label will be blown off directly without movement of the applicator.
The dimensioning of the adjusted time (unit = value x 10ms) should correspond to the ac-
tual time for the extension of the whole stroke. If the specified value is exceeded because
of another parameter configuration, the label will be blown off immediately onto the prod-
uct, unless the labeler waits of a trigger signal (e.g. “BLOW TRIGGER” or from the sensor
“variable stroke”). When using the option “variable stroke” normally the EXTENSION TIME
is set on a low value (e.g. “002”) to continue with the variable range of the stroke after a
constant extension length.
*Fast forward-function when pushing the button [] or [].
CONFIGURATION 016
EXTENS. DELAY 000
CONFIGURATION 017
EXTENSION TIME 080
To Next Page
Loading...
Need help?
General
