Chapter 6 Installation and Initial Operation Alpha Compact 32708612
Version: 14.12.2012 page 34 of 135
6. Installation and Initial Operation
Installation
Only an optimally aligned installation of the system can ensure a continuous operation
with a low rate of failures and a minimum wear. For an optimized installation of the sys-
tem, fine tunings adapted to environmental conditions are essential. For the fine tunings, a
complex expert knowledge is required basing on experience with labeling technique.
The complexity of a wear-optimized installation requires a high measure of specialized
knowledge and experience, which cannot be obtained completely by reading this manual.
Therefore the installation of the labeler must be made by a technician from the Bluhm
Weber Group or examined by a final inspection. Damage or damages based on an incor-
rect installation, represent no case of warranty.
Furthermore additional information on initial operation and maintenance is available in the
Service Manual.
Requirements to the Site of Installation
Closed and clean room.
Level surface, solid floor, unevennesses must not exceed 5 mm if stands of the
Bluhm Weber Group are used.
Floor with adequate carrying capacity: 1500 kg/m².
Low vibration environment.
Adequate illuminating: 500 Lx.
No direct irradiation from sun light or heaters.
The machine must not operate in areas with electrostatic or magnetic fields. This
can result in malfunctions of the controller.
Correct air and power supply according to the chapter "Technical Data".
Placing the Labeler
The labeler may not contact the product.
The installation position has to provide sufficient access for user and service
technician. In particular at all times, the mains switch / plug must be freely acces-
sible to disconnect the power supply
Observe that all mounting parts are fixed sufficiently.
Consider all points of the "Intended Use" in the chapter safety regulations.
*² Only if system is equipped accordingly.
To Next Page
Loading...
Need help?
General
