Chapter 2 Safety Regulations Alpha Compact 32708612
Version: 14.12.2012 page 20 of 135
Health hazard caused by rough surfaces
HEALTH HAZARD!
The friction rollers have a rough surface. Long contact may cause
abrasions.
Do not grip in, at or between moving parts.
Health Hazard due to inappropriate handling of lubricants and
detergents
HEALTH HAZARD!
For used lubricants and detergents, the valid information of the
safety data sheets of the manufacturers and the valid safety- and
disposal regulations have to be observed and followed for each
product.
Risk of injury at angles and edges
RISK OF INJURIES!
Sharp angles and edges may cause grazing and gashes at the
skin. Keep the working place always clean. The label web builds
sharp angles.
If work is performed close to sharp angles and edges, proceed
cautious. Remove parts that are not required.
In case of doubt wear safety gloves.
Attention when inserting and changing label web.
Engine (motor) and controller have to be grounded (ground-
ing screw next to motor plug). Short time overloads influence
the internal direct-current voltage in a negative way (chassis
on 0V potential) and should be avoided.
Remaining Risks
The labeler is constructed for a safe operation. Hazards that are not preventable due to
construction purposes are limited as far as possible by protection devices. A certain
amount of risk is always existent! The knowledge about the remaining risks assists you to
arrange your work safer and to avoid incidents. In order to avoid the dangers, please ob-
serve additionally the particular security advice in the single chapters.
To Next Page
Loading...
Need help?
General
