To Next Page

To Previous Page

Chapter 8 System Options Alpha Compact 32708612

Version: 14.12.2012 page 86 of 135

FUNCTION-MENU

You can reach the function menu by pushing [] and [Enter] at the same time assuming

that the labeler is in stand-by (s.a.). This menu includes some basic settings of the labeler

with the following submenus:

 LABEL COUNTER

 RESET COUNTER

 LCD SETTINGS

 LANGUAGE SELECTION (Option)

 EVENT COUNTER

 SAVE CONFIGURATION

 LOAD CONFIGURATION

LABEL COUNTER

Here you have the opportunity to determine the label counter a certain value between 0-

25599. You activate the countdown function by an input value larger “00000”. That means

the input value will be counted down during each applying cycle in the labeling mode. The

display indicates a “minus” forward the counter value. The counter value corresponds to

the remaining applying cycles. The labeler will stop automatically if the final value “-0000”

is reached.

 Push the * buttons [] or [] to reach the next parameter.

 Push [Enter] to edit the front digits or push again [Enter] to change to the back

digits.

 Push the * buttons [] or [] to increase or reduce the edited parameter value

(cursor flashes).

 Push [Start] or [Stop] to leave the parameter settings.

*Fast forward-function when pushing the button [] or [].

FUNCTION-MENU



FUNCTION-MENU

LABEL COUNTER 01234

Weber ALPHA COMPACT User Manual

Questions and Answers: