Weber ALPHA COMPACT - Label Position (Label Pos.); Label Position CM; Speed (Speed); Speed M;Min

Chapter 8 System Options Alpha Compact 32708612
Version: 14.12.2012 page 92 of 135
002 LABEL POSITION (LABEL POS.)
Herewith the label position to the peeler bar is adjusted manually. There is the possibility
of automatic label calibration.
 Push [Enter] to edit the configuration parameter (in case of password query see
page 91).
 Push the *buttons [] or [] to increase or reduce the value.
 Push [Enter] to confirm the entry.
 Push [Start] or [Stop] to leave the parameter setting.
* Fast forward-function when pushing the button [] or [].
003 SPEED (SPEED)
Here the application rate is adjusted. This speed should correspond to the speed at which
the product is transferred to the labeler. By using a rotating shaft encoder there is the
possibility that the controller identifies automatically the product speed and also reacts on
varying product speeds.
 Push [Enter] to edit the configuration parameter (in case of password query see
page 91).
 Push the *buttons [] or [] to increase or reduce the value.
 Push [Enter] to confirm the entry.
 Push [Start] or [Stop] to leave the parameter setting.
CONFIGURATION 02
LABEL POSITION cm: 11,8
CONFIGURATION 03
SPEED m/min: 0.50