Chapter 10 Troubleshooting Alpha Compact 32708612
Version: 14.12.2012 page 124 of 135
Correcting Adjustments based on Labeler Result
Based on the labeler result you can draw conclusions from the necessary adjustments
The following requirements have to be complied:
- One or several sample products.
- Control of product supply.
- Labeler is connected with power supply and *²compressed air.
- Initial Operation is finished.
Product with a good Labeler Result
Fig. 10-1: Product with a good Labeler Result
Description:
The label is free from creases, straight and always at the same position on the product.
Instruction:
No corrections are necessary!
To Next Page
Loading...
