Weber ALPHA COMPACT - Page 70

Chapter 6 Installation and Initial Operation Alpha Compact 32708612
Version: 14.12.2012 page 70 of 135
Please adjust the coupling as follows.
Step Procedure
1
Loosen the setscrew (Fig.: 6-27, Pos.6).
2
Loosen the adjusting screw (Fig.: 6-27, Pos.4).
3
Push the dancer arm (Fig.: 6-27, Pos.2) in direction of the adjustment (to the
cover) and keep it pushed.
4
Tighten slightly the adjusting screw (Fig.: 6-27, Pos.4).
5
Release again the dancer arm (Fig.: 6-27, Pos.2).
6
Loosen the adjusting screw slightly (Fig.: 6-27, Pos.4) until the dancer arm
moves slowly backward by the spring force.
7
If the dancer arm achieves an angle of appr. 45 degree to the cover, please
tighten again the adjusting screw (Fig.: 6-27, Pos.4).
8
Tighten then finally the setscrew again (Fig.: 6-27, Pos.6).