Maintenance
5562−1/A1
Winterthur Gas & Diesel Ltd.
5/ 5
5. Installation
1) Do a check of the lip seal (9, Fig. 1). Replace the lip seal if necessary.
2) Make sure that the sealing surfaces of the PCV and the valve block are clean
and have no damage.
3) Put the PCV in position on valve block (3).
4) Put oil on the threads of the four screws (8).
5) Put the four screws (8) in position in the PCV, then tighten the screws in the
sequence given in Fig. 2, view I
as follows:
a) Tighten the screws with your hand.
b) Torque the screws to 80 Nm.
c) Torque the screws to 190 Nm.
6) Attach the fuel return pipe (5, Fig. 1) to the PCV (1).
7) Tighten the angle union (7).
8) Connect the electrical connection to the solenoid valve (2).
2015
Fuel Pressure Control Valve: Removal, Check, Installation
To Next Page
Loading...
Need help?
General
