WinGD X72 - 6708-1;A1

Maintenance
6708−1/A1
Winterthur Gas & Diesel Ltd.
1/ 6
Removal and Installation
Tools:
2 Manual ratchet, H1/H2 94016−009 2 Shackle, WLL 3250 kg 94018A
WLL 1600 kg 3 Lifting tool 94667
2 Manual ratchet, H3/H4 94016−031 1 Holder 94667G
WLL 500 kg 1 Holder 94667H
1. Preparation 1.......................................................
2. Removal Procedure 2...............................................
2.1 Front Water Separator 2.......................................
2.2 Rear Water Separator 3........................................
3. Installation 5.......................................................
3.1 Rear Water Separator 5........................................
3.2 Front Water Separator 5.......................................
1. Preparation
1) Read the data in 0012−1. General
Guidelines for Lifting Tools
2) Remove the front and rear cover from
the housing of the water separator (1,
see Fig. 1 and Fig. 2).
3) Install the tools (94667) to the front and
rear of the water separator (1).
4) Install the holder (94667H) to the front
frame (5) as shown.
5) Install the holder (94667G) to the rear
frame (6) as shown.
6) Remove the bottom plate (3) and the
beam (2).
7) Attach the manual ratchet (H3) to the
holder (94667H) and the tool (94667).
8) Attach the manual ratchet (H4) to the
holder (94667G) and the tool (94667).
9) Attach the manual ratchet (H1) to the
shackle (94018A) on the gallery above
water separator.
94667
G
94667
H4
WCH02416
Fig. 2
6
2015
Water Separator
H3
94667
94667
H
3
1
4
H1
WCH02415
Fig. 1
2
5