Maintenance
5562−1/A1
Winterthur Gas & Diesel Ltd.
1/ 5
Removal, Check, Installation
Tools:
1 HP oil pump 94931 1 HP hose 94935
1 Pressure gauge 94934A 1 PCV test block with tube 94556
1. General 1..........................................................
2. Preparation 1.......................................................
3. Removal 2.........................................................
4. PCV Check 3.......................................................
4.1 Preparation 3.................................................
4.2 Adjustment Procedure 4.......................................
4.3 Setpoint Check 4.............................................
5. Installation 5.......................................................
1. General
To prevent failure of the pressure control valve (PCV), WinGD Ltd recommends that
you only do the procedures that follow:
D Do a check and adjust the PCV.
D Adjust the PCV.
D Replace the PCV.
For the maintenance intervals of the PCV refer to the Maintenance Schedule 0380−1,
Fuel pressure control valve.
2. Preparation
1) Stop the engine.
2) Release the pressure in the fuel rail. Do the procedure given in the Operation
Manual 0515−1, paragraph 5.
WARNING
Injury hazard. Use gloves and eye protection. Hot fuel can come
out as a spray and cause injury.
WARNING
Fire hazard. Do not weld or grind materials in the area. Sparks can
cause a fire.
3) Make sure that the work area is clean.
Fuel Pressure Control Valve
2015
To Next Page
Loading...
Need help?
General
