To Next Page

To Previous Page

Maintenance

Group0

Winterthur Gas & Diesel Ltd.

1/ 1

General Information Group 0

For Particular Attention 0000−1/A1..................................................................

Preface 0001−1/A1.................................................................................

Table of Contents 0002−1/A1.......................................................................

Engine Numbering and Designations 0008−1/A1.....................................................

General Guidelines

for Maintenance: Safety Measures and Warnings 0011−1/A1........................................

for Lifting Tools: Wire Rope Slings, Span-sets, Eye Bolts etc. 0012−1/A1..............................

Clearance Table 0330−1/A1.........................................................................

General Page 1...............................................................................

Crankshaft and Thrust Bearing 2, 3..............................................................

Crankshaft and Main Bearing 4, 5................................................................

Crosshead Guide 6, 7..........................................................................

Cylinder Liner 8, 9.............................................................................

Piston Rod Gland 10, 11........................................................................

Exhaust Valve 12, 13...........................................................................

Top and Bottom End Bearings to Connecting Rod 14, 15............................................

Piston Cooling and Crosshead Lubricating Link 16, 17..............................................

Piston and Piston Rings 18, 19..................................................................

Driving Wheels for Supply Unit 20, 21............................................................

Fuel and Servo Pump Units 22, 23...............................................................

Fuel Pump 24, 25..............................................................................

Tightening Values of Important Screwed Connections 0352−1/A1.....................................

Torque Values and Elastic Stud Replacement − Standard Screws and Elastic Studs 0352−2/A1..........

Masses (Weights): Individual Components per Piece in kg 0360−1/A1.................................

Maintenance Schedule: Inspection and Overhaul Intervals (Guidelines) 0380−1/A1.....................

Engine Cross Section and Longitudinal Section 0803−1/A1...........................................

Winterthur Gas & Diesel Ltd. X72 / MM / 2015

WinGD X72 Maintenance Manual

Other manuals for WinGD X72