7-24
Alarm Configuration
• EmailMessage: Enables/Disables email notification for this alarm. (Default = On)
• Address1,2,and3: These parameters are used to select which of the three email
addresses defined via the "Email Messages" menu (see Section 5.9.11) will receive
the email alarm notification messages generated by this alarm. The Address
parameters can be used to select one, or any combination of the addresses defined
via the Email Messages menu. (Default = All On)
Note:IfEmailaddresseshavebeenpreviouslyspecified,thenthetextunder
theparameterswilllistthecurrent,userdefinedemailaddresses.
• Subject: This parameter is used to define the text that will appear in the "Subject"
field for all email notification messages generated by this alarm. (Default = "Alarm:
Plug Current")
• PlugShedding: Allows individual plugs to be automatically switched Off or left
On when current consumption at the plug rises above the user-defined high Plug
Threshold value. (Default = Leave On)
Note:InordertoenablePlugShedding,youmustfirstsetthehighPlug
Thresholdvalueforeachdesiredplug.
• PlugGroupShedding: Allows user-defined Plug Groups to be automatically
switched Off or left On when current consumption by the Plug Group rises above
the user-defined high Plug Group Threshold high. (Default = Leave On)
Note:InordertoenablePlugGroupShedding,youmustfirstsetthehighPlug
GroupThresholdforeachdesiredPlugGroup.
To Next Page
Loading...
Need help?
General
