17-15
Command Reference Guide
/N Network Port Parameters - IPv4
Displays a menu used to select IPv4 protocol parameters for the Network Port. All
functions provided by the /N command are also available via the Web Browser Interface.
For more information, please refer to Section 5.9.
Availability: Administrator
Format: /N [Enter]
/N6 Network Port Parameters - IPv6
Displays a menu used to select IPv6 protocol parameters for the Network Port. All
functions provided by the /N6 command are also available via the Web Browser
Interface. For more information, please refer to Section 5.9.
Availability: Administrator
Format: /N6 [Enter]
/N0 Network Port Parameters - Ethernet Port 0, IPv4 (DE Units Only)
When configuring network parameters for TSM/RSM units that include dual Ethernet
ports, the /N0 command is used to select IPv4 protocol parameters for Ethernet Port 0.
Note that this command is not available on TSM/RSM units that include only one
Ethernet port. For more information, please refer to Section 5.9.
Availability: Administrator
Format: /N0 [Enter]
/N1 Network Port Parameters - Ethernet Port 1, IPv4 (DE Units Only)
When configuring network parameters for TSM/RSM units that include dual Ethernet
ports, the /N0 command is used to select IPv4 protocol parameters for Ethernet Port 1.
Note that this command is not available on TSM/RSM units that include only one
Ethernet port. For more information, please refer to Section 5.9.
Availability: Administrator
Format: /N1 [Enter]
/N6 0 Network Port Parameters - Ethernet Port 0, IPv6 (DE Units Only)
When configuring network parameters for TSM/RSM units that include dual Ethernet
ports, the /N6 0 command is used to select IPv6 protocol parameters for Ethernet
Port 0. Note that this command is not available on TSM/RSM units that include only one
Ethernet port. For more information, please refer to Section 5.9.
Availability: Administrator
Format: /N6 0 [Enter]
/N6 1 Network Port Parameters - Ethernet Port 1, IPv6 (DE Units Only)
When configuring network parameters for TSM/RSM units that include dual Ethernet
ports, the /N6 1 command is used to select IPv6 protocol parameters for Ethernet
Port 1. Note that this command is not available on TSM/RSM units that include only one
Ethernet port. For more information, please refer to Section 5.9.
Availability: Administrator
Format: /N6 0 [Enter]
To Next Page
Loading...