17-17
Command Reference Guide
/I Reboot System (Default)
Reinitializes the TSM/RSM unit and offers the option to keep user-defined parameters or
reset to default parameters. As described in Sections 5.10.1 and 15.3, the /I command
can also be used to restore the unit to previously saved parameters. When the /I
command is invoked, the unit will offer four reboot options:
• Reboot Only (Do NOT default parameters)
• Reboot & Default (Keep IP Parameters & SSH Keys; Default all other parameters)
• Reboot & Default (Default ALL parameters)
• Reboot & Restore Last Known Working Configuration
Availability: Administrator
Format: /I [Enter]
/UF Upgrade Firmware
When new versions of the TSM/RSM firmware become available, this command is used
to update existing firmware as described in Section 16.
Notes:
• TheFirmwareUpgradeUtilityisthepreferredmethodformanagingTSM/RSM
firmwareupgrades.The/UFcommandisintendedtoprovideanalternative
totheFirmwareUpgradeUtility.Formoreinformation,pleasereferto
Section16.1
• Whenafirmwareupgradeisperformed,theTSM/RSMwillrequire15minutes
fortheupgradeprocedure.
Availability: Administrator
Format: /UF [Enter]
/CP Copy RS232 Port Parameters
Allows quick set-up when several serial ports will be configured with similar parameters.
When the /CP command is invoked, the TSM/RSM will display a menu that can be used
to copy parameters to RS232 ports. For more information, please refer to Section 5.8.3.
Note:ToproceedwiththeCopyfunctionafterselectingnewparameters,
press[Esc];theTSM/RSMwillthendisplaytheconfirmationpromptbefore
proceeding.
Availability: Administrator
Format: /CP [Enter]
To Next Page
Loading...
Need help?
General
