WTI TSM Series - Page 35

5-6
Basic Configuration
• TemperatureFormat: Determines whether the temperature is displayed as
Fahrenheit or Celsius. (Default = Fahrenheit)
• TemperatureCalibration: Used to calibrate the unit's internal temperature sensing
abilities. To calibrate the temperature, place a thermometer inside your equipment
rack, in a location that usually experiences the highest temperature. After a few
minutes, take a reading from the thermometer, and then key the reading into the
configuration menu. In the Web Browser Interface, the temperature is entered
at the System Parameters menu, in the Temperature Calibration field; in the Text
Interface, the temperature is entered in a submenu of the System Parameters menu,
which is accessed via the Temperature Calibration item. (Default = undefined)
• LogConfiguration: Configures the Audit Log, Alarm Log and Temperature Log.
For more information on event logging functions, please refer to Section 5.3.3.
(Default = Audit Log = On without Syslog, Alarm Log = On without Syslog,
Temperature Log = On)
Notes:
• TheAuditLogwillcreatearecordofallpowerswitchingandreboot
activityattheTSM/RSMunit,includingrebootsandswitchingcausedby
LoadShedding,LoadSheddingRecovery,PingNoAnswerRebootsand
ScheduledReboots.
• TheAlarmLogwillcreatearecordofeachinstancewhereanAlarmis
triggeredorclearedattheTSM/RSMunit.
• TheTemperatureLogwillcreatearecordofambientracktemperatureover
time.
• TheTemperatureLogfeatureisnotavailableonsomeTSM/RSMmodels.
• CallbackSecurity: Enables and configures the Callback Security Function as
described in Section 5.3.4. In order for this feature to function correctly, a Callback
number must also be defined for each desired user account as described in
Section 5.5. (Default = On - Callback without Password Prompt, 3 attempts,
30 Minute Delay)
Notes:
• IntheTextInterface,CallbackSecurityParametersaredefinedviaasubmenu
oftheSystemsParametersMenu,accessedviatheCallbackSecurityitem.
• IntheWebBrowserInterface,CallbackSecurityParametersaredefined
viatheCallbackSecuritysubmenu,whichisaccessedviatheGeneral
Parametersmenu,locatedonthelefthandsideofthescreen.
• FrontPanelButtons: This item can be used to disable all front panel button
functions. (Default = On)
• ModemPhoneNumber: When the TSM/RSM unit includes an internal modem, the
Modem Phone Number parameter can be used to record the phone number for the
modem. (Default = undefined)