To Next Page

To Previous Page

5-38

Basic Configuration



 ModemMode: Permits access to command mode and simplifies connection

to an external modem. Modem Mode ports can perform all functions normally

available in Any-to-Any Mode, but Modem Mode also allows definition of a Hang-

Up String, Reset String, and Initialization String:

 ModemResetString: Redefines the modem reset string. The Reset String

can be sent prior to the Initialization string. (Default = ATZ)

 ModemInitializationString: Defines a command string that can be sent to

initialize a modem to settings required by your application.

(Default = AT&C1&D2S0=1&B1&H1&R2)

 ModemHang-UpString: Although the TSM/RSM will pulse the DTR line to

hang-up an attached modem, the Hang-Up string is often useful for controlling

modems that do not use the DTR line. (Default = undefined)

 PeriodicResetValue: Determines how often the Reset String will be sent to

the modem at this port. (15 Minutes)

 NoDialtoneEnable: When this item is "On" the No Dialtone Alarm can be

enabled as described in Section 7.9. When the No Dialtone Alarm is enabled,

the TSM/RSM can provide notification if the unit detects that a phone line

connected to a modem installed at this port is dead. (Default = Off)

Note:WhencommunicatingwiththeTSM/RSMviamodem,theseparameters

willnotbechangeduntilafteryouexitcommandmodeanddisconnect.



ModemPPPMode: Allows data that is normally sent via ethernet to be sent via

phone line. When Modem PPP Mode is selected, the following modem-related

parameters will be available:

 ResetString: Redefines the modem reset string. The Reset String can be

sent prior to the Initialization string. (Default = ATZ)

 InitializationString: Defines a command string that is used to initialize the

modem to settings required for PPP communication

(Default = ATQ0V1E1S0=0&C1&D2)

 Hang-UpString: Although the TSM/RSM will pulse the DTR line to hang-

up an attached modem, the Hang-Up string is often useful for controlling

modems that do not use the DTR line. (Default = undefined)

 PeriodicResetInterval: Determines how often the Reset String will be sent

to the modem at this port. (Default = 15 Minutes)

 NoDialtoneEnable: When this item is "On" the No Dialtone Alarm can be

enabled as described in Section 7.9. When the No Dialtone Alarm is enabled,

the TSM/RSM can provide notification if the unit detects that a phone line

connected to a modem installed at this port is dead. (Default = Off)

WTI TSM Series User Manual

Questions and Answers: