WTI TSM Series User Manual

5-39
Basic Configuration
 PeriodicResetLocation: The IP address or URL for the website that will be
used to keep the PPP connection alive when not in use. The TSM/RSM will
regularly ping the selected IP address or URL in order to keep the connection
alive. (Default = undefined)
Notes:
• InordertoselectadomainnameasthePeriodicResetLocation,youmust
firstdefinetheDomainNameServersasdescribedinSection5.9.5.
• TheIPAddress,P-t-PandSubnetMaskparameterscannotbedefined
bytheuserandwillbeautomaticallysuppliedbytheISPwhenaPPP
communicationisstarted..
 PPPPhoneNumber: The phone number for the line that will be used for PPP
communication. (Default = undefined)
 UserName: The user name for the ISP account that will be used for PPP
communication. (Default = undefined)
 Password: The password for the ISP count that will be used for PPP
communication (Default = undefined)
 IPAddress: The temporary IP address that will be assigned to the PPP
communication session by the ISP. Note that this item cannot be defined
by the user and will be automatically supplied by the ISP when a PPP
communication session is started. (Default = undefined)
 P-t-P: Note that this item cannot be defined by the user and will be
automatically supplied by the ISP when a PPP communication session is
started. (Default = undefined)
 SubnetMask: Note that this item cannot be defined by the user and will
be automatically supplied by the ISP when a PPP communication session is
started. (Default = undefined)
• Heartbeat: The Heartbeat parameter can be used in conjunction with the Lost
Communication alarm to provide notification when a WTI device that has been
attached to one of the TSM/RSM's serial ports ceases to function. Normally, the
TSM/RSM will send the Heartbeat message to an attached WTI device at regular
intervals; if the attached device fails to respond to the Heartbeat message, the
TSM/RSM can then notify you via email, Syslog Message or SNMP Trap as
described in Section 7.3. Note that the Heartbeat feature is only available when the
TSM/RSM serial port has been configured for "Any-to-Any" mode. (Default = Off)
Notes:
• TheHeartbeatfunctionwillonlyworkiftheportisconfiguredforAny-to-Any
mode.InordertoemploytheLostCommunicationAlarm,alltargetports
mustbeconfiguredforAny-to-Anymode.
• InorderfortheLostCommunicationAlarmtofunction,itmaybenecessaryto
updatethefirmwareonyourremoteWTIequipment.

WTI TSM Series Specifications

General

Brand	WTI
Model	TSM Series
Category	Remote Control
Language	English