WTI TSM Series User Manual

5-40
Basic Configuration
NetworkServices:
• DirectConnect: Direct Connect allows users to access the TSM/RSM and
automatically create a connection between the Network Port and a specific serial
port by including the appropriate Telnet port number in the connect command (e.g.
Port 5 = 2105). For more information, please refer to Section 10.3. As described
below, the Direct Connect feature offers three options. (Default = Off)

Off: Telnet users will not be able to employ the Direct Connect feature to
connect to this port.

On-NoPassword: Telnet users will be able to employ the Direct Connect
feature to connect to this port without entering a password.

On-Password: Telnet and SSH users will be able to use Direct Connect
to connect to this port, but will be required to enter a password before the
connection is established.

Off-BreakonRawDisconnect: The port will send a break character when
a Raw Socket connection with the port is terminated. Note that this feature
will work with both the "No Password" and "Password" options as described in
Section 10.3.2. In the default state this feature is disabled; no break character is
sent when a Raw Socket connection is terminated.
Note:If"On-Password"isselected,andAdministratorlevelcommands
aredisabledattheNetworkPort,thenonlyaccountsthatdonotpermit
Administratorlevelcommandswillbeallowedtoestablishadirectconnection
viatheNetworkPort.IfAdministratorlevelcommandsaredisabledatagiven
port,thenthatportwillnotallowaccessbyaccountsthatpermitAdministrator
levelcommands.
WhenthePortParametersmenuisaccessedviatheTextInterfaceandthe
DirectConnectfeatureisenabled,themenualsolistsbothDirectConnectport
numbersforthisport(portnumbersarenotlistedintheWebBrowserInterface.)

TelnetPort: The Telnet port number employed to create a Direct Connection to
this port using standard Telnet protocol.

SSHPort: When Direct Connect (Item 31) is set at "On - Password", this line will
display the Telnet port number used to create a Direct Connection to this port
using SSH protocol. For more information, please refer to Section 10.

RawPort: The Telnet port number that is used to create a Direct Connection to
this port using Raw Socket protocol.

WTI TSM Series Specifications

General

Brand	WTI
Model	TSM Series
Category	Remote Control
Language	English