WTI TSM Series User Manual

5-49
Basic Configuration
• SYSLOGAddresses: Defines the IP addresses for the Syslog Daemon(s) that
will receive log records generated by the TSM/RSM. Allows definition of IP
addresses for both a primary Syslog Daemon and an optional secondary Syslog
Daemon. SYSLOG Addresses can be entered in either IPv4 or IPv6 format, or in
domain name format (up to 64 characters.) For more information, please refer to
Section 11. (Default = undefined)
Notes:
• TheSyslogAddresssubmenuintheTextInterfaceandtheNetwork
ParameterssubmenuintheWebBrowserInterfacebothincludeaPingTest
functionthatcanbeusedtopingtheuser-selectedSyslogIPAddressesin
ordertoverifythatvalidIPaddresseshavebeenentered.Inorderforthe
PingTestfeaturetofunction,yournetworkand/orfirewallmustbeconfigured
toallowpingcommands.
• InadditiontothePingTestfeature,the/TESTcommandintheTextInterface
orthe"Test"optionintheWebBrowserInterfacecanalsobeusedtoping
thecurrentlydefinedSyslogAddressesinordertomakecertainthattheIP
addressesareresponding.
• PingAccess: Enables/Disables response to the ping command. When Disabled,
the TSM/RSM will not respond to Ping commands. Note that disabling Ping Access
at the Network Port will not effect the operation of the Ping-No-Access Alarm.
(Default = On)
• OutboundAccess: Enables/Disables the ability to create outbound Telnet and/
or SSH connections via the TSM/RSM's Network Port. When enabled, users who
are connected to the TSM/RSM command mode via one of the serial ports will be
able to connect to the Network Port, and then invoke the /TELNET and/or /SSH
commands to create an outbound connection. For example, to create an outbound
Telnet connection, first make certain that this option is enabled for both the serial
port and the password/account, then access command mode via the Text Interface
at a free serial port. At the RSM> prompt, invoke the /TELNET command as
described in Section 10.5. (Default = Off)
• RawSocketAccess: Enables/Disables Raw Socket Protocol access to the
Network Port via Direct Connect and selects either port 3001 or 23 for Raw Socket
Access. (Default = Off)
• ModemHuntTelnet: This option enables the TSM/RSM to support modem
pooling in conjunction with third party Serial Port Redirector software as described
in Section 5.9.2.1. (Default = Off)
• ModemHuntRaw: Same as Modem Hunt Telnet, except this function uses a raw
socket connection. For more information, please refer to Section 5.9.2.1.
(Default = Off)
Note:The"ModemHuntTelnet"optionisrecommendedfortransmittingASCII
dataandthe"ModemHuntRaw"optionisrecommendedfortransmittingbinary
data.

WTI TSM Series Specifications

General

Brand	WTI
Model	TSM Series
Category	Remote Control
Language	English