06/2014
0-4
WC 5022/5024
0.3 Description for Terminology And Symbols
Version 1.0
Introduction
0.3 Description for Terminology And Symbols
The terms and symbols used throughout this manual are explained
here.
• The terms and symbols used at the beginning of a text are defined as follows:
WARNING
Indicates an imminently hazardous situation, such as death or serious injury if opera-
tors do not handle the machine correctly by disregarding the statement.
WARNING
Indicates a potentially hazardous situation, such as death or serious injury if operators
do not handle the machine correctly by disregarding the statement.
CAUTION
Indicates a potentially hazardous situation, such as injury or property damage if operators do
not handle the machine correctly by disregarding the statement.
Instruction: Used to alert you to a procedure which, if not strictly observed, could result in dam-
age to the machine or equipment.
NOTE: Used when work procedures and rules are emphasized.
Used when other explanations are given.
Used to describe the purposes of Adjustment and Troubleshooting.
REP: Indicates the disassembly/assembly procedure for reference.
ADJ: Indicates the adjustment procedure for reference.
PL: Indicates the parts list for reference.
Terminology
Installation of any part other than the ones designated by Xerox shall be strictly prohibited
because it cannot be guaranteed in quality and safety.
Important Information Stored Component (ISC)
This component stores all the important customer information that is input after the installation.
When performing replacement, follow the procedures in 'Chapter 4 Disassembly/Assembly
and Adjustment' to replace/discard. Make absolutely sure that no customer information gets
leaked outside.
Table 1 Terminology
Terminology Description
Assy Means Assembly.
TEC Value Abbreviation of Typical Electricity Consumption, which means the stan-
dard power consumption. Read as 'tec'.
To Next Page
Loading...
Need help?
General
