Xerox WorkCentre 5022 Service Manual

06/2014
3-3
WC 5022/5024
3.1.1 Composition of Chapter 3 Image Quality Trouble-
Image Quality Troubleshooting
Version 1.0
3.1.1 Composition of Chapter 3 Image Quality
Troubleshooting
1. Chapter 3 Image Quality Troubleshooting is mainly composed of two sections: Test Pat-
tern and Image Quality Troubleshooting.
2. The Test Pattern section contains the method to output the Built-in Test Patterns for the
copy quality check.
3. The Image Quality Specifications section also contains [6.1.22 Alignment Specifications].
4. The Image Quality Troubleshooting section describes the causes of image quality failures
and the troubleshooting procedure for them.
3.1.2 Test Pattern
The following are the test patterns that are used.
1. The copy quality check mainly uses the Test Pattern (Mono A3) (499T 00247).
2. For copy quality check, Standard paper is used.
3. The Built-in Test Patterns are stored in the following locations.
a. IOT ESS/MCU PWB
4. For the Test Patterns, refer to the following.
• 6.5.2.9 Test Pattern Print

Xerox WorkCentre 5022 Specifications

General

Copy Resolution	Up to 600 x 600 dpi
Scan Resolution	Up to 600 x 600 dpi
Connectivity	USB 2.0
Functions	Print, Copy, Scan
Duplex Printing	Manual
Paper Sizes	A3, A4, A5, B4, B5
Memory (Standard)	128 MB
Print Technology	Laser
Print Speed	Up to 22 ppm
Print Resolution	600 x 600 dpi
Copy Speed	Up to 22 cpm
Operating System Compatibility	Windows, Mac
First Page Out Time (Copy)	8 seconds