Xerox WorkCentre 5022 Service Manual

06/2014
3-13
WC 5022/5024
3.3.1 IOT Image Defect Sample
Image Quality Troubleshooting
Version 1.0
3.3.1 IOT Image Defect Sample
This section describes some Defect Samples and the actions to be taken in case of the follow-
ing IOT problems:
• IDS1 Auger Mark
• IDS2 Strobing (27 mm or 13.5 mm Pitch Density)
• IDS3 White Streaks (Process Direction)
• IDS4 Black Bands
• IDS5 Toner Contamination
• IDS6 Toner Splattering
• IDS7 White Spots (Irregular)
• IDS8 Regular Blank Areas in Process Direction (Spots, Streaks, Bands etc.)
• IDS9 Regular Toner Contamination in Process Direction (Spots, Streaks, Bands etc.)
• IDS10 Regular Toner Contamination in Process Direction (Side 2)
3.3.2 IIT Image Defect Sample
This section describes some Defect Samples and the actions to be taken in case of the follow-
ing IIT problems:
• IDS11 Moire Due to Interference With Copy Documents
• IDS12 Light Background Due to Background Suppression in Copies of Documents With
Frames
• IDS13 Background Smear When Using Platen Copy With Non-Standard Documents
• IDS14 Fluctuation In Background Suppression Values for Copies of Documents With
Medium Density
• IDS15 Defects Related To Scan Print
• IDS16 Cold Start Dew
• IDS17 Static Electricity Offset [occurs after approx. 80 mm (the Heat Roll cycle)]

Xerox WorkCentre 5022 Specifications

General

Copy Resolution	Up to 600 x 600 dpi
Scan Resolution	Up to 600 x 600 dpi
Connectivity	USB 2.0
Functions	Print, Copy, Scan
Duplex Printing	Manual
Paper Sizes	A3, A4, A5, B4, B5
Memory (Standard)	128 MB
Print Technology	Laser
Print Speed	Up to 22 ppm
Print Resolution	600 x 600 dpi
Copy Speed	Up to 22 cpm
Operating System Compatibility	Windows, Mac
First Page Out Time (Copy)	8 seconds