06/2014
5-3
WC 5022/5024
5.1.1 How to Use the Parts List
Parts List
Version 1.0
5.1.1 How to Use the Parts List
Chapter 5 Parts List contains information on spare parts.
The parts list is used to order replacement parts and enter area codes. To use the parts list
correctly, read the description below carefully.
<How to find out parts No needed>
To shorten the time searching for a Parts No., a navigation screen (illustration) is provided to
search for the relevant parts in the illustration. When you have already identified a parts to be
checked, search for the relevant parts on this screen (illustration) to perform servicing
efficiently. For how to use the navigation, refer to ’5.1.5 Using Parts Navigation’.
5.1.2 Precautions
• To make the illustration easy to see, hardware such as screws are shown in alphabets.
Their shapes are not shown.
• Read notes in the Description column carefully before ordering and replacing parts.
• Handling Safety Critical Components shall conform to Xerox-stipulated rules and
regulations on Safety Critical Components.
As to replacement of any component designated SCC, the complete component unit must
be replaced. It must never be disassembled or no individual internal parts of it must be
replaced.
Installation of any part other than the ones designated by Xerox shall be strictly prohibited
because it cannot be guaranteed in quality and safety.
• ISC followed by part name in the DESCRIPTION column represents Important
Information Stored Component that stores important customer information. To replace
and discard an ISC, follow the procedure for it described in chapter 4.
• The area codes are shown on plates each. The area codes (such as toner and Current
Adjustment values) which cannot be shown as parts on plates are listed on the list of area
codes at the end of this chapter.
To Next Page
Loading...
Need help?
General
