Xerox WorkCentre 5022 Service Manual

06/2014
4-39
WC 5022/5024
Repairs and Asdjustments
Version 1.0
REP 10.6.2 STM Takeaway Motor
Parts List on PL 10.6
Removal
WARNING
When turning OFF the power switch, check that the 'Data' lamp is OFF and that there is
no Job in progress.
Turn OFF the power switch and make sure that the screen display turns OFF.
Check that the power switch is OFF and unplug the power plug.
CAUTION
Static electricity may damage electrical parts.
Always wear a wrist band during servicing. If a wrist band is not available, touch some metallic
parts before servicing to discharge the static electricity.
1. [Two Tray Module]
Remove the Cap. (Figure 1)
a. Release the hook to remove the Cap.
Figure 1 j0mg41001
2. [Two Tray Module]
Disconnect the connector. (Figure 2)
a. Remove the cable band.
b. Disconnect the connector.
Figure 2 j0mg41002
3. Remove the Docking Bracket (x2). (Figure 3)
a. Remove the Docking Screw (x2).
b. Remove the Docking Bracket (x2).
Figure 3 j0lj41003
4. Remove the Rear Cover of the One Tray Module. (Figure 4)
a. Remove the screw (x2).
b. Remove the Rear Cover.

Xerox WorkCentre 5022 Specifications

General

Copy Resolution	Up to 600 x 600 dpi
Scan Resolution	Up to 600 x 600 dpi
Connectivity	USB 2.0
Functions	Print, Copy, Scan
Duplex Printing	Manual
Paper Sizes	A3, A4, A5, B4, B5
Memory (Standard)	128 MB
Print Technology	Laser
Print Speed	Up to 22 ppm
Print Resolution	600 x 600 dpi
Copy Speed	Up to 22 cpm
Operating System Compatibility	Windows, Mac
First Page Out Time (Copy)	8 seconds