Xerox WorkCentre 5022 - Page 145

06/2014
2-123
WC 5022/5024
077-101 Regi Sensor Off Jam
Status Indicator RAPs
Version 1.0
077-101 Regi Sensor Off Jam
BSD-ON: CH8.4, CH4.1
The Regi Sensor did not turn OFF within the specified time after the Regi Clutch On.
Cause/Action
Check the following:
• The Regi Sensor (Input Check [071-105]) for operation failure. (PL 15.1)
• The Main Drive Motor (Output Check [042-001]) for operation failure. (PL 3.1)
• The Regi Clutch (Output Check [071-001]) for operation failure. (PL 15.1)
• The Regi Roll and Pinch Roll for transportation failure due to contamination, wear, and
deterioration.
• The Transfer Unit for a decrease in the transportation force.
• The Drive Gear for wear and damage.
• A paper transportation failure due to foreign substances on the paper path.
• Usage of out of spec paper.
If no problems are found, replace the ESS/MCU PWB (PL 18.3).
077-103 Fusing Unit Exit Sensor Off Jam (Long)
BSD-ON: CH10.3, CH4.1, CH10.4
After the Regi Sensor Off, the Fusing Unit Exit Sensor did not turn OFF within the specified
time.
Cause/Action
Check the following:
• The Fusing Unit Exit Sensor (Input Check [071-106]) for operation failure. (PL 7.1)
• The Main Drive Motor (Output Check [042-001]) for operation failure. (PL 3.1)
• The Invert Motor (Output Check [071-003] (Exit)) for operation failure. (When Duplex is
installed) (PL 17.1)
• The Exit Roll and Pinch Roll for transportation failure due to contamination, wear, and
deterioration.
• The Transfer Unit for a decrease in the transportation force.
• The Heat Roll for wound up, stuck paper.
• The Drive Gear for wear and damage.
• Usage of out of spec paper.
If no problems are found, replace the ESS/MCU PWB (PL 18.3).