7 Digital Operator/Panel Operator
7.3.3 Output Circuit Signal Allocation
7-26
7.3.3 Output Circuit Signal Allocation
Functions can be allocated to the following sequence output signals. After having changed the parameter, turn
OFF the power and ON again to enable the parameters.
means factory setting.
1. When two or more signals are allocated to the same output circuit, a signal is output with OR logic.
2. The signals not detected are considered as “Invalid.” For example, Positioning Completion (/COIN) Sig-
nal in speed control mode is “Invalid.”
CN1 Pin No. 25/(26) 27/(28) 29/(30)
Remark
Parameter Setting
Allocation
Pn512=n.xxx
Pn512=n.xx
x Pn512=n.x
xx
010101
Positioning
Completion
(/
COIN)
Pn50E.0 = n.xxx
0 Invalid
L:
Valid output signal: Low level
H:
Valid output signal: High level
Invalid:
Do not use the output signal.
Factory Setting
Note:
The output signals for Positioning
Completion Signal and Speed Coinci-
dence Detection Signal differ depend-
ing on the control method.
1L H
2LH
3LH
Speed Coinci-
dence Detection
(/V-CMP)
Pn50E.1 = n.xxx
0 Invalid
1L H
2LH
3LH
Rotation Detection
(/TGON)
Pn50E.2 = n.xxx
0 Invalid
1L H
2LH
3LH
Servo Ready
(/S-RDY)
Pn50E.3 = n.xxx
0 Invalid
1L H
2LH
3LH
Torque Limit
Detection
(/CLT)
Pn50F.0 = n.xxx
0 Invalid
1L H
2LH
3LH
Speed Limit
Detection
(/VLT)
Pn50F.1 = n.xxx
0 Invalid
1L H
2LH
3LH
Brake
(/BK)
Pn50F.2 = n.xxx
0 Invalid
1L H
2LH
3LH
Warning
(/WARN)
Pn50F.3 = n.xxx
0 Invalid
1L H
2LH
3LH
Near
(/NEAR)
Pn510.0 = n.xxx
0 Invalid
1L H
2LH
3LH
Pn512:
Pn510:
Pn50F:
Pn50E:
IMPORTANT
To Next Page
Loading...
Need help?
General
