YASKAWA SGDH - Page 605

11 Appendix
11.3.2 List of Parameters
11-42
* 1. Normally set to “0.” When using an external regenerative resistor, set the allowable power loss (W)
of the regenerative resistor.
* 2. The upper limit is the maximum output capacity (W) of the SERVOPACK.
Pn510 Output Signal Selections 3
−−0000 After
restart
−
Pn511 Reserved (Do not change)
−−8888 Immedi-
ately
−
Pn512 Output Signal Reversal Settings
−−0000 After
restart
7.3.3
Pn600
Regenerative Resistor Capacity
∗1
Depends on SERVO-
PACK Capacity
∗2
10 W 0 W Immedi-
ately
6.5
Pn601 Reserved (Do not change)
Depends on SERVO-
PACK Capacity
∗2
− 0 W Immedi-
ately
−
Parameter
No.
Name Setting Range Unit Factory
Setting
Setting
Validation
Reference
Section
0
1
2
3
Disabled (the above signal is not used.)
Outputs the signal from CN1-25 or -26 terminals.
Outputs the signal from CN1-27 or -28 terminals.
Outputs the signal from CN1-29 or -30 terminals.
Near Signal Mapping (/NEAR)
(Refer to "8.6.6 Positioning Near Signal.")
4th
digit
3rd
digit
2nd
digit
1st
digit
n.
Reserved (Do not change)
Reserved (Do not change)
Reserved (Do not change)
0
1
0
1
0
1
Output signal is not reversed.
Output signal is reversed.
Output signal is not reversed.
Output signal is reversed.
Output signal is not reversed.
Output signal is reversed.
Output Signal Reversal for CN1-25 or -26 Terminals
4th
digit
3rd
digit
2nd
digit
1st
digit
n.
Output Signal Reversal for CN1-27 or -28 Terminals
Output Signal Reversal for CN1-29 or -30 Terminals
Reserved (Do not change)