EasyManua.ls Logo

YASKAWA VIPA SPEED7 - Page 143

YASKAWA VIPA SPEED7
1007 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
DONE
(SEND)
NDR
(RECV)
ERROR STATUS Description
0 - 1 8184h System error occurred
- 0 1 8184h System error occurred
(source data area failure).
0 - 1 8185h Parameter LEN exceeds source area SEND.
0 1 8185h Destination buffer (RECV) too small.
0 0 1 8186h Parameter ID invalid (not within 1 ...16).
0 - 1 8302h No receive resources at destination station, receive station is
not able to process received data fast enough res. has no
receive resources reserved.
0 - 1 8304h The connection is not established. The send command
shouldn’t be sent again before a delay time of > 100ms.
- 0 1 8304h The connection is not established. The receive command
shouldn’t be sent again after a delay time of > 100ms.
0 - 1 8311h Destination station not available under the defined Ethernet
address.
0 - 1 8312h Ethernet error in the CP.
0 1 8F22h Source area invalid, e.g. when area in DB not present Param-
eter LEN < 0
- 0 1 8F23h Source area invalid, e.g. when area in DB not present Param-
eter LEN < 0
0 - 1 8F24h Range error at reading a parameter.
- 0 1 8F25h Range error at writing a parameter.
0 - 1 8F28h Orientation error at reading a parameter.
- 0 1 8F29h Orientation error at writing a parameter.
- 0 1 8F30h Parameter is within write protected 1. recent data block
- 0 1 8F31h Parameter is within write protected 2. recent data block Data
block
0 0 1 8F32h Parameter contains oversized DB number.
0 0 1 8F33h DB number error
0 0 1 8F3Ah Area not loaded (DB)
0 - 1 8F42h Acknowledgement delay at reading a parameter from periph-
eral area.
- 0 1 8F43h Acknowledgement delay at writing a parameter from periph-
eral area.
0 - 1 8F44h Address of the parameter to read locked in access track
- 0 1 8F45h Address of the parameter to write locked in access track
0 0 1 8F7Fh Internal error e.g. invalid ANY reference e.g. parameter LEN
= 0.
0 0 1 8090h Module with this module start address not present or CPU in
STOP.
VIPA SPEED7
Network Communication
Ethernet Communication > FC 6 - AG_RECV - Receive from CP 343
HB00 | OPL_SP7 | Operation list | en | 18-30 143

Table of Contents

Related product manuals