YASKAWA VIPA SPEED7 - Usage in Siemens TIA Portal

13.4.6 Usage in Siemens TIA Portal
13.4.6.1 Precondition
n Please use the Siemens TIA Portal V 14 and up for the configuration.
n The configuration of the VIPA CPU with PWM functionality happens in the Siemens
TIA Portal by means of a virtual PROFINET IO device.
n The PROFINET IO Device is to be installed in the hardware catalog by means of a
GSDML.
The installation of the PROFINET VIPA IO device happens in the hardware catalog with
the following approach:
1. Go to the service area of www.vipa.com.
2. Download the according file for your system - here System MICRO from the down-
load area via ‘Config files è PROFINET’.
3. Extract the file into your working directory.
4. Start the Siemens TIA Portal.
5. Close all the projects.
6. Switch to the Project view.
7.
Select ‘Options è Install general station description file (GSD)’.
8. Navigate to your working directory and install the according GSDML file.
ð
After the installation the hardware catalog is refreshed and the Siemens TIA
Portal is closed.
After restarting the Siemens TIA Portal the according PROFINET IO device can
be found at Other field devices > PROFINET > IO > VIPA GmbH > VIPA MICRO
PLC.
Thus, the VIPA components can be displayed, you have to deactivate the
"Filter" of the hardware catalog.
13.4.6.2 Hardware configuration
To be compatible with the Siemens SIMATIC TIA Portal the following steps should be
executed:
1. Start the Siemens TIA Portal with a new project.
2. Switch to the Project view.
3. Click in the Project tree at ‘Add new device’ .
Overview
Installing the VIPA IO
device
Add CPU in the project
VIPA SPEED7
Motion control - Simple Motion Control Library
Usage inverter drive via PWM > Usage in Siemens TIA Portal
HB00 | OPL_SP7 | Operation list | en | 18-30 443