Code Description
0x80D4 Channel 0:
Input value measurement period > 8 388 607µs
0x80D5 Channel 1:
Input value measurement period > 8 388 607µs
Code Description
0x808x System error on the bus coupler
0x8090 LADDR_OUT is wrong, possible reasons:
n there is no module configured on this address
n limitation of the length of consistent data
was not considered
n Basic address in parameter LADDR_OUT
was not entered in hexadecimal type
0x8093 There is no bus coupler existing for LADDR_OUT, from which consis-
tent data can be read.
0x80A0 An access error was detected during peripheral access.
0x80B0 System error on the bus coupler
0x80B1 Specified length of the source area does not correspond to the config-
ured user data length.
0x80B2 System error on the bus coupler
0x80B3 System error on the bus coupler
0x80C1 The data from the previous read request on the module are not pro-
cessed by the module, yet.
0x80C2 System error on the bus coupler
0x80Fx System error on the bus coupler
0x85xy System error on the bus coupler
0x8xyy General error information
Ä
Chap. 4.2 ‘General and Specific Error Information RET_VAL’
page 66
12.1.3 FC 301 - FM_GET_PERIOD - Calculate period duration consistent
With the FC 301 FM_GET_PERIOD, you can calculate the period duration of the input
signals of both channels of the System SLIO frequency measurement module. By this
function internally SFC 14 - DPRD_DAT for consistent reading of user data is called.
Here, the error messages of the function block are returned by ERROR.
Errors of the internally
called SFC 15
Description
VIPA SPEED7
Device Specific
Frequency Measurement > FC 301 - FM_GET_PERIOD - Calculate period duration consistent
HB00 | OPL_SP7 | Operation list | en | 18-30 248
To Next Page
Loading...
