ERROR = TRUE indicates that an error has occurred during processing. For details refer
to parameter STATUS. The following table contains all the error information specific to
SFB 33 that can be output with the ERROR and STATUS parameters.
ERROR STATUS
(decimal)
Description
0 11 Message lost: The previous signal change or the previous message could not be
sent and will be replaced by the current message.
0 22
n Error in the pointer to the associated values SD_i:
– relating to the data length or the data type
– Associated values in the user memory not accessible, for example, due to
deleted DB or area length error. The activated message is sent without asso-
ciated values or if necessary with even possible number of associated
values.
n The actual parameter you have selected for SEVERITY is higher than the per-
mitted range. The activated message is sent with SEVERITY = 127.
0 25 Communication was initiated. The message is being processed.
1 1 Communication problems: Disconnection or no logon With acknowledgement-trig-
gered reporting active: temporary display, if no display devices support acknowl-
edgement-triggered reporting.
1 4 At the first call the specified EV_ID is outside the permitted range or the ANY pointer
SD_i has a formal error or the maximum memory area that can be sent for the CPU
per SFB 31 was exceeded.
1 10 Access to local user memory not possible (for example, access to a deleted DB)
1 12 When the SFB was called: an instance DB that does not belong to SFB 31 was
specified or a shared DB instead of an instance DB was specified.
1 18 EV_ID was already being used by one of the SFBs 31 or 33 ... 36.
1 20 Not enough working memory.
1 21 The message with the specified EV_ID is disabled.
After the first block call, the ACK_UP and ACK_DN outputs have the
value 1 and it is assumed that the previous value of the SIG input was 0.
14.2.14 SFB 34 - ALARM_8 - Messages without associated values (8x)
Generating block-related messages without associated values for 8 signals.
n SFB 34 ALARM_8 is identical to SFB 35 ALARM_8P.
n Except the associated values are not transferred.
Error information ERROR /
STATUS
Description
Parameter
VIPA SPEED7
Integrated Standard
System Function Blocks > SFB 34 - ALARM_8 - Messages without associated values (8x)
HB00 | OPL_SP7 | Operation list | en | 18-30 754
To Next Page
Loading...
